Melkbosstrand, Sunset Beach & Flamingo Vlei

Cold Room Installation & Repairs

Walk-in chillers for kitchens, bottle stores and small producers.

Call 012 546 5996

A cold room is a building inside a building. It only holds temperature when the panels, the vapour barrier, the door and the refrigeration plant all work together. Get one of those wrong and the unit runs continuously while the room slowly warms.

Reyds works on walk-in chillers for cafés, restaurants, bottle stores, guest houses and small food producers across the territory. That includes new panel rooms, replacing tired condensing units, and fixing rooms that have never held temperature properly since the day they were built.

What this covers

  • Insulated panel rooms, floors and ceilings
  • Condensing units and evaporator selection
  • Door heaters, seals and closers
  • Defrost cycles and drain tracing
  • Temperature mapping and alarm points
  • Vapour barriers and condensation control
  • Plant relocation and pipework
  • Servicing and planned maintenance

Signs it needs attention

  • Room temperature creeping up overnight
  • Heavy ice on the ceiling or floor
  • Door seal frozen to the frame or not closing flush
  • Condensing unit running without stopping
  • Water or ice around the door threshold

How the work runs

01

Check the envelope first

Before touching the plant we look at panels, joints, door and penetrations. A room losing temperature through a broken seal will not be fixed by a bigger unit.

02

Match plant to duty

Pull-down load, product load and door openings decide the plant size. We size for the worst day, not the quietest one.

03

Commission with evidence

We log the room through a full cycle so you can see it holding temperature before stock goes in, and set alarms at sensible limits.

Where this service runs

Questions we get asked

Can you convert a chiller room into a freezer room?

Sometimes, but it is not just a thermostat change. Panels, floor insulation, door heating, defrost and the plant all have to suit freezing temperatures. We assess the existing envelope before recommending it.

Why does my cold room ice up?

Usually the defrost cycle, a blocked drain or air leaking in past the door. Ice on the evaporator reduces airflow, which raises product temperature, which makes the unit run longer and ice up faster.

Do you build rooms in existing buildings?

Yes. Most of the rooms we work on are retrofits into a back-of-house area, garage or storeroom. The first step is a site check on floor levels, headroom and where the condensing unit can reject heat.

Next step

Need cold rooms on the West Coast?

Call, WhatsApp or send the enquiry form. Tell us the rooms, cabinets or room involved and we will confirm what an assessment covers.